Juergensen Marine
HERE'S WHERE WE'RE SELLING SOME OF OUR REBREATHER RELATED GEAR.
NEED A 3 SENSOR CAPABLE, HUD INTEGRATED CCR CONTROL?? GO HERE!
MOST OF THIS STUFF IS PRETTY UNIQUE - SO IT IS FIRST COME, FIRST SERVED!
 |
SOLD!!! SOLD!!! SORRY, ALL GONE. On Consignment, we have received a Brand New, Never Dove Mark 15 CCR! This unit is pristine, and has never seen water! Set Contains: Mark 15 UBA Inconel Spheres Secondary Display Primary Display (Analog elect) Manual Scott DSV! If you are interested in this rare purchase, then Call or E-Mail Us for more information!
|
 |
This is our Heads Up Display Board. This unit is about the same dimensions as a 9 volt battery (which it can run off of), but only about 1/3 of and inch thick. The LED will flash Green for each point above 1.0, and Red for each point below - Orange (both Green and Red LED Flashing) means a ppO2 of 1.0. This unit can be used with one to three sensors. As shown (without battery or cable): $300 |
 |
This is the Stainless Steel (304) bracket we have for mounting the single Tri-Color LED onto. You can then use the slot in the back of the bracket to screw this onto your DSV or Mask. We'll include this with the order for the HUD above - you may very well have a better way of hooking this up, but you may like to have the bracket anyway. And if you ask real nice, we'll even throw in a couple of Stainless sheet metal screws to attach it to your favorite DSV. |
 |
This is just showing the RED side of the LED - it glows Green too, depending upon your ppO2. I could also post a picture of it flashing Green, but you can use your imagination, can't you? |
 |
Here is the Switch used in the Mark 15 Secondary Display. This is a Mil Spec part, which has a Sealed Shaft, as well as an integral Panel Seal. This is a two pole, 5 position compact switch. The reason the Mark 15 used a 5 position switch was so that the diver could select the following for monitoring via a Secondary Display Meter (above): 1)Sensor 1 Output 2) Sensor 2 Output 3) Sensor 3 Output 4) + Side of Battery 5) - Side of Battery With all this said, you could utilize this switch for monitoring most anything you'd like. You would need to construct a housing around this switch, of course, but that could be as simple as a square box. These switches are BRAND NEW and we are selling them for $75 each. |
TAKE ME TO THE HEADS UP DISPLAY MANUAL!
THE
ALL NEW "HAMMERHEAD™" REPLACEMENT HEAD FOR THE BUDDY INSPIRATION™!!!!
THE
ALL NEW "SMA-1" DIGITAL CONTROL UNIT FOR THE KISS™ REBREATHER!!!!
O.K. - I've seen the place, now I want to meet the Family...
Rebreather Modifications